Olivetti Fax-Lab 480 Instructions Manual page 22

F ,
OR TRANSMISSION LIFT THE HANDSET
1. Place the original document in the ADF.
The display shows on the top line:
and on the bottom line, the default contrast value: NORMAL.
The initial resolution value (even if it is not shown on the
display) is: " " (standard).
If you want, change the contrast and resolution values as
described previously.
2. Lift the handset to engage the line.
The display shows:
and the length of the transmission in minutes and seconds in
the top right-hand corner.
3. To select the recipient number, press the keys:
-
The recipient's number may contain a maximum of 64 digits.
If your correspondent's fax machine is set up for automatic
reception, you will hear the fax machine signal.
If it is set up for manual reception, the correspondent
himself will answer. Ask him to press the start key on his
fax. Then wait for the fax signal.
4. To start sending, press the key:
The message "CONNECTING" appears on the display. If
the document is sent correctly, once this operation has been
completed, the display will show the message "TX
COMPLETED" for a few seconds.
A
UTOMATIC REDIAL
If no connection is established due to line errors or because the
recipient's number is busy, the fax machine automatically redials
the number up to five times.
16
T
RANSMITTING ORIGINAL AT A PRESET TIME
( )
DELAYED TRANSMISSION
This function enables you to solve time zone problems if
your correspondent is located thousands of kilometres away
and to avoid paying high prices by choosing time bands
when there is less traffic on the telephone lines.
1. Place the original document in the ADF. On the upper line,
the display shows:
and on the bottom line, the default contrast value: NORMAL.
The initial resolution value (even if it is not shown on the
display) is: " " (standard).
If you want, change the contrast and resolution values as
described previously.
2. Press the key
until the display shows:
3. Press the key:
The display shows:
Enter the time at which you want to transmit the document.
For example "16:50".
4. To do so, press the keys:
-
5. Press the key:
The display shows:
Dial your recipient's number in any of the available methods:
directly on the numeric keypad or using the one-touch keys
or speed dialling codes (see "Setting one-touch and
speed dialling").
6. Press the keys:
-
7. To confirm the entry, press the key:
The display shows "TX SET." for a few seconds and then:
Note
You can cancel the "delayed transmission" setting. Do so by removing
the document from the ADF or by pressing the
N o t e
If there is a power failure, the delayed transmission will be
cancelled.
key.