Factory Default Settings
Before configuring your, you need to know the following default settings.
Web Interface (Username and Password)
Username: admin
Password: admin
The default username and password are "admin" and "admin" respectively.
If you ever forget the username/password to login to the router, you may press the
RESET button for 6 – 8 seconds to restore the factory default settings.
Caution: After pressing the RESET button for more than 6 seconds, to be sure you power
cycle the device again.
Attention
Attention
Device LAN IP settings
IP Address: 10.0.0.2
Subnet Mask: 255.255.255.0
ISP setting in WAN site
PPPoE
DHCP server
DHCP server is enabled.
Start IP Address: 10.0.0.100
IP pool counts: 100
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
LAN Port
IP address
Subnet Mask
DHCP server function
IP addresses for distribution
to PCs
Chapter 3: Basic Installation
10.0.0.2
255.255.255.0
Enabled
100
IP
addresses
10.0.0.100 through 10.0.0.199
Billion 400G Router
WAN Port
The WAN protocol has been
pre-selected and set by Telkom
for automated service
deployment and delivery.
continuing
from
13