T
O SEND A DOCUMENT
W
HAT DOCUMENTS MAY BE USED
Dimensions
IN THE AUTOMATIC DOCUMENT FEEDER (ADF)
• Width
210 mm
• Length
105 mm - 600 mm
• Unit weight
70 - 90 gr/m
IN THE AUXILIARY MANUAL DOCUMENT FEEDER
• Width
148 mm - 216 mm
• Length
105 mm - 600 mm
• Unit weight
70 - 110 gr/m
N
EVER USE
•
curled paper
•
excessively thin paper
•
torn paper
•
damp or set paper
•
excessively small paper
•
crumpled paper
•
carbon paper
In addition, in order to avoid damaging your fax machine and invali-
dating your guarantee, make sure that the documents you are to use
do not contain:
•
staples
•
paper clips
•
adhesive tape
•
correcting liquid or glue that has not yet dried.
In all these cases, photocopy the document and send the copy.
T
O PLACE THE DOCUMENT IN THE ADF OR MANUAL
DOCUMENT FEEDER
1. Push the paper support extension in the slot until it clicks into
position.
T
RANSMISSION AND RECEPTION OPERATIONS
2
(max. 5 sheets)
2
(1 sheet at a time)
1
2
2. Insert the document in the automatic document feeder (ADF - fig.
1) with the side to be sent facing downwards.
Place the document in the auxiliary manual document feeder as
follows:
•
Place the document against the right-hand side of the feeder
(fig. 2).
•
Make sure that the document has been fed at least three
centimetres into the feeder as this indicates that it is correctly
inserted. If this is not the case, remove the document by press-
ing the
key and repeat the operation.
3. Once the document has been inserted in either of the feeders, the
display shows on the top line:
and on the bottom line, the default contrast value: "NORMAL".
T
O ADJUST THE CONTRAST AND RESOLUTION
Before sending a document you can make some adjust-
ments so as to optimize the printing quality.
T
O ADJUST THE CONTRAST
1. Press the key
until the display shows:
2. Press the key:
The display shows:
3. Press the key:
The display shows:
or
or
3