Device; Toll Saver - Olivetti Fax-Lab 128 Instructions Manual

Procedure for operating the TAD from a remote loca-
t i o n :
• Dial the fax number on the remote telephone. The TAD will
answer the call and start communicating.
• Type your access code on the remote telephone. The code
must be entered before outgoing message 1 is played.
• If the code is correct, the TAD will confirm the operation by
emitting a beep.
• Choose the function that you want to perform and type its
code, which will be confirmed by a beep - see the table below.
CODE OPERATING FUNCTION
0 The current operating function will be aborted.
1 Plays new messages.
2 Plays all messages.
3 Stops playing current message and returns to
previous message.
4 Stops playing current message and skips to next
message.
5 Playing outgoing message 1.
6 + 6 Deletes all played messages.
CODE PROGRAMMING FUNCTION
0 The current programming function will be aborted.
# 1 Disables the "TAD/FAX" reception mode and
enables the "AUTOMATIC" reception mode.
# 2 Sets up the fax machine for "TAD/FAX" reception
mode.
# 3 Enables a new OUTGOING MESSAGE 1 to be re-
corded.
# 4 Enables the OUTGOING MESSAGE ONLY to be
played.
If the current programming function was aborted by pressing
0, press # again to be able to make other settings.
If any code is typed during the recording of outgoing mes-
sage 1 (programming #3), the TAD will stop immediately and
cancel the recording of outgoing message 1.
S
PECIAL FUNCTIONS OF THE TELEPHONE
ANSWERING DEVICE
You can set up the TAD for the following special functions:
•

TOLL SAVER

• OUTGOING MESSAGE ONLY
• SILENT RECEPTION OF INCOMING MESSAGES
T
OLL SAVER
Using this function, when you access the TAD from a
remote location to listen to any messages, the fax ma-
chine will answer as follows:
• if there are no new messages, it will answer the call
two rings after the number preset;
• if there are some new messages, it will answer the
call after the preset number of rings (see "To
change the number of rings", chapter "More so-
phisticated operations").
Therefore, if you hear one ring more than the preset
number, you will know that there are no new mes-
sages and you can hang up before the fax machine
answers the call.
This function may only be enabled by the customer
engineering service and is not available in all coun-
tries.
1. Press the key:
The display shows:
2. Press the keys
until the display shows:
3. Press the key:
The display shows:
4. Press the keys
until the display shows:
5. To confirm the setting, press the key:
The display shows:
6. To view the other available option, "TOLL SAVER -
YES", press the keys:
3 9