Moving Tool Information - Nautilus Commercial Series TreadClimber TC916 Assembly Manual

MoVInG InsTRUcTIons
movingToolinformation
MoVInG Tool PaRTs:
The following parts are shown in the figure to the
right, in order listed:
• Wheel Bar – one frame, two wheels, two clevis clips
• Caster Cart – one base, two wheels
• Lifting Tool – one piece
• Two 4x4x6 inch (ca. 10x10x15.5 cm) Blocks of Wood
- not pictured
befoRe MoVInG THe Tc916 UnIT:
1 - Make sure the power cord is not running under
the machine.
UsaGe DIRecTIons:
step 1: Lift the right side of the TC916 and brace with a
4x4x6 inch (ca. 10x10x15.5 cm) block of wood near
the middle of the machine.
step 2: Lift the left side of the TC916 and brace with a
4x4x6 inch (ca. 10x10x15.5 cm) block of wood near
the middle of the machine.
step 3: Slide the Wheel Bar under the machine near the
front of the TC916. Tilt the TC916 towards the rear,
raising the front of the machine to provide room to
slide the Wheel Bar underneath.
step 4: Tilt the machine forward, towards the Console and
slide the Caster Cart under the rear of the machine
(see Figure 1). Position the Caster Cart under the
machine flush with the bottom of the frame so that
it hooks between the frame and the leveling pads.

0
cleVIs clIP fRaMe
caster cart
Wheel bar
figure 1
figure 2
WHeel