Nautilus Commercial Series TreadClimber TC916 Assembly Manual page 31

step3: c onnectingGroundWirestrapstobaseassembly
Locate the following for this step:
Parts:
• assembly from step 2
• 3 grounding straps
hardware:
• 4 self-tapping screws - .25 x .50 (P/n 22139)
• 5 Lock Washers (P/n - 41260)
Tools:
• Phillips screw driver
3-1 remove the 3 grounding straps, 4 self-Tapping screws,
and 5 Lock Washers from the parts bag.
3-2 attach one end of a grounding strap to the right side
of base frame with one screw and lock washer. (see
figure 3 - grounding strap #1.)
imPorTanT!
pl ace ring terMinal of the
cable bet ween the screw anD lock washer.
3-3 attach the other end of grounding strap to the cross
bar of the lower upright weldment with a screw and
lock washer . (see figure 3 - grounding strap #1.)
3-4 attach one end of second grounding strap to the left
side of base frame with one screw and washer. (see
figure 3 - grounding strap #2.)
3-5 attach the other end of second grounding strap with
one end of third grounding strap to the cross bar of
the lower upright weldment with a screw and two
washers. (see figure 3 - grounding strap #2 and #3,
and figure 3a.)
imPorTanT!
le ave other enD of thirD
grounDing str ap free. it will be installeD
in step 10 of asseMbly process.
asseMbly InsTRUcTIons
figure 3: Connecting ground Wire straps
ground Wire
strap - #3
ground Wire
figure 3a: Connecting ground Wire straps #2 & #3
ground Wire strap - #3
ground Wire
strap connection
between - #2 & #3.
ground Wire strap - #2
Nautilus® TreadClimber® Model TC916 Assembly Manual
ground Wire
strap - #2
strap - #1
1