Moving Unit Into Position In Facility - Nautilus Commercial Series TreadClimber TC916 Assembly Manual

MoVInG InsTRUcTIons
movingunitintoPositioninFacility
noTe: Perform the following moving procedure to position
your TreadClimber
your door ways are greater than 40 inches wide.
Tools needed:
 7/16 Socket
 Ratchet
 Moving Dolly
 Lift Bar
step 1: Remove TC916 from pallet by performing steps
in section "Removing Machine from Pallet" in
this manual.
step 2: Tilt to 40 degrees (see Figure 1). While tilted
place 4-wheel moving dolly under center of
TreadClimber
WHen loWeRInG THe TReaDclIMbeR
UnIT onTo Dolly be sURe THaT THe
casToRs aRe lockeD so THaT IT Does
noT MoVe oUT fRoM UnDeR THe
®
TReaDclIMbeR
step 3: Carefully, lower the TreadClimber
onto 4-wheel moving dolly (see Figure 3).
step 4: Once in position in the facility, prepare to
remove unit from 4-wheel dolly by locking
castors.

14
Model TC916 in your facility if
®
® frame (see Figure 2).
®
UnIT.
®
Model TC916
figure 1
figure 2
figure 3
figure 4