Completing The Setup Wizard - Symantec 460R - Gateway Security Installation Manual

4
5

Completing the Setup Wizard

Before performing these procedures, you must complete the tasks in
page 20 and the procedures that are specific to the type of connection you have.
To complete the Setup Wizard
1
2
3
4
5
IP Address Type the static IP address.
Default Gateway Type the IP address of the default gateway.
DNS 1 Type the IP address of the first Domain Name Service (DNS) server used to translate
addresses.
DNS 2 Optionally, type the IP address of an additional DNS server used to translate addresses.
DNS 3 Optionally, type the IP address of an additional DNS server used to translate addresses.
Click Next>>.
Skip to "Completing the Setup Wizard"
In the System Information panel, do the following:
Security Gateway Host Name
Domain Name
admin's Password
Verify Password
Block ICMP Requests
Click Next>>.
In the LiveUpdate Settings panel, do the following:
Run LiveUpdate Now To run LiveUpdate after the Setup Wizard is complete, check this check box.
Enable Scheduler To run Scheduler, check this check box.
LiveUpdate Server Type the IP address of the LiveUpdate server.
Frequency Select the frequency with which LiveUpdate checks for updates. The default frequency is
Daily.
Preferred Time (UTC) Type the time of day at which you want LiveUpdate to check for updates.
The time is based on a 24-hour clock. The format is HH:MM, where HH is hour and MM is
minutes. For example, to run the Live Update at 5:30 pm, type 17:30.
Click Next>>.
In the Confirmation panel, review the settings, and then do one of the following:
To make changes, click <<Back.
To save the settings and restart the appliance, click Apply Settings.
It takes a few minutes for the appliance to apply the settings and restart.
on page 23.
Type the name of the gateway host.
You can leave the default value, change it if required by your ISP, or leave it
blank.
Optionally, type the domain name.
Type the administrator account password.
The administrator user name is always admin.
Retype the administrator account password.
To not permit PING requests, click Enable. To permit PING requests, click
Disable.
Running the Setup Wizard
Running the Setup Wizard
"Starting the Setup Wizard"
23
on