Configuring A Dsl Connection; Configuring A Static Ip Address Connection - Symantec 460R - Gateway Security Installation Manual

22 Running the Setup Wizard
Running the Setup Wizard

Configuring a DSL connection

Before performing these procedures, you must complete the tasks in
page 20.
To configure a DSL connection
1
2
3
4
5
6
7

Configuring a static IP address connection

Before performing these procedures, you must complete the tasks in
page 20.
To configure a static IP address connection
1
2
3
Run the Setup Wizard.
See "Starting the Setup Wizard"
In the Connection Types panel, click DSL.
In the Broadband ADSL/SDSL Connection Authentication panel, select the user authentication service.
If you selected PPPoE, in the Broadband ADSL/SDSL Connection with PPPoE panel, do the following:
User Name Type the account user name.
Password Type the account password.
Verify Password Retype the account password.
Connect on Demand To establish the connection on an as-needed basis, check this check box.
Idle Time Out Type the time, in minutes, after which the connection closes if idle.
Static IP address Type the static IP address.
If you selected PPTP, in the Broadband ADSL Connection with PPTP panel, do the following:
User Name Type the account user name.
Password Type the account password.
Verify Password Retype the account password.
Server IP Address Type the server IP address.
Connect on Demand To establish the connection on an as-needed basis, check this check box.
Idle Time Out Type the time, in minutes, after which the connection closes if idle.
Static IP address Type the static IP address.
Click Next>>.
Skip to "Completing the Setup Wizard"
Run the Setup Wizard.
See "Starting the Setup Wizard"
In the Connection Types panel, click Static IP.
In the Broadband connection using a Static IP panel, do the following:
IP Address Type the static IP address.
Network Mask Type the network mask.
on page 20.
on page 23.
on page 20.
"Starting the Setup Wizard"
"Starting the Setup Wizard"
on
on