Adjusting The Fader; Adjusting The Balance; Linear Setting; Loudness On/ Off - Becker DTM High Speed 7910 Operating Manual

General Operation

Adjusting the Fader

Press the button. Then press the multifunction button
.
Adjust the fader setting to the desired level by pressing the
right rotary control .

Adjusting the Balance

Press the button. Then press the multifunction button
.
Adjust the balance to the desired level by pressing the right
rotary control .
86

Linear Setting

Press the button briefly.
Press the multifunction button
will be displayed. By pressing the multifunction button
again, the tone adjustments for the current signal source (i.e.
FM) will be reset to mid-level.

Loudness On/ Off

Press the button then press the multifunction button
.
Using the multifunction button
( ) or Loudness Off ( ) can be selected.
In the MW, LW and SW wavebands, Loudness is switched
off.
briefly -
either Loudness On