Becker Online Pro 7800 Installation Manual page 7

G
The driver's field of vision must not be obstructed.
G
Clean adhesion surfaces (inside and outside) with the enclosed cleaning cloth.
After cleaning, wait until the cleaned surfaces have dried.
b. Completely pull off protective paper from the adhesive surface (the square piece as well) (2). Caution: The
adhesive part is now exposed.
First adhere the external unit (A) with the slot at the top to the glass by firmly pressing (approx. 3-5 seconds)
around the circumference of the external unit base.
Subsequently, affix internal unit (B) to the inside of the window, once again by pressing on the housing of the unit
for approx. 3-5 seconds, with the circular area centred in the middle of the outside unit (centre point = centring
axis).
Depending upon the amount of space, the position of the internal unit can be turned on this centring axis before
being directly affixed.
)
The ideal adhesion temperature is between +15 °C and +25 °C.
The adhesive foil will adhere immediately to the adhesion surface and cannot be repositioned. It is not possible
to reuse the adhesive foil.
c. Run connecting cable to the installation position of the GSM/GPS Box.
Subject to errors and technical changes
37
Installation Guide
Copyright by Becker GmbH, D-76303 Karlsbad