•
Remove grease from flex cable and connect dog to flex cable.
Using a suitable installation tool, press the dog onto the flex cable
(Figure 9).
)
When pressing in, ensure that the dog is securely positioned
and that it runs smoothly.
•
Pull the hose sleeve and nut as far as possible in the direction of the
dog, to achieve approx. 1-2 mm play (Figure 10).
Slightly squeeze the hose sleeve with pliers. Wrap with isolating
tape to secure (Figure 11).
•
Screw the connecting piece and the speed sensor into the cable
(Figure 12).
•
Electrically connect the speed sensor using the extension cable
from VDO (part number: 2152.90 30 0100).
Wire connections for the speed sensor
Brown
-
earth (terminal 31)
Black
-
power supply (terminal 15), 9 - 16V, 30 mA
Blue/red -
signal for socket A pin 1
Subject to errors and technical changes
Figure 9
Figure 10
Figure 12
47
Installation Guide
Figure 11
Copyright by Becker GmbH, D-76303 Karlsbad