Dell PowerVault NX3100 Hardware Owner's Manual page 13

Item Indicator, Button,
or Connector
2 Power-on indicator/
power button
3 NMI button
4 System identification
button
5 Hard drives
Icon Description
The power-on indicator lights
when the system power is on.
The power button controls the
DC power supply output to the system.
When the optional system bezel is
installed, the power button is not
accessible.
NOTE:
the video monitor can take from several
seconds to over 2 minutes to display an
image, depending on the amount of
memory installed in the system.
NOTE:
systems, turning off the system using the
power button causes the system to
perform a graceful shutdown before
power to the system is turned off.
NOTE:
press and hold the power button for
five seconds.
Used to troubleshoot software and
device driver errors when using certain
operating systems. This button can be
pressed using the end of a paper clip.
Use this button only if directed to do so
by qualified support personnel or by the
operating system's documentation.
The identification buttons on the front
and back panels can be used to locate
a particular system within a rack.
When one of these buttons is pushed,
the blue system status indicator on the
back blinks until one of the buttons is
pushed again.
Up to twelve 3.5-inch or 2.5-inch,
hot-swappable SAS or SATA drives.
When powering on the system,
On ACPI-compliant operating
To force an ungraceful shutdown,
About Your System
13