AT&T MERLIN LEGEND Communications System Release 2.0 Maintenance And Troubleshooting Manual page 42

Introduction to System Maintenance
6. When the Password: prompt appears, type the password (do not
press
[ Enter ]
The SPM Main menu appears. You are ready to proceed with remote
maintenance.
Dialing the Modem Directly
To dial the modem directly, do the following:
1. Start SPM, press any key when the welcome message appears, and
enter the command to put the modem in originate mode (this command
varies depending on the type of modem used).
Pick up the handset on the tip/ring telephone and dial the remote
2.
access trunk number.
This is possible only when a trunk is programmed as a dedicated
for remote access to the built-in modem.
You will hear ringing, followed by dial tone.
3.
If the dial tone begins with three short tones followed by a steady one,
dial the access barrier code on the tip/ring telephone. Otherwise, go to
the next step.
NOTE:
4.
When you hear the dial tone, dial
remote system.
1-14 Equipment
).
If you do not know the remote access barrier code, contact
the customer's system administrator, or check Form 3a,
Incoming Trunks—Remote Access.
You can change the access barrier code without knowing
the old one only when you are on-site and connected to the
SPM jack on the processor.
10 to connect to the modem on the
trunk