To enter thermometer mode to display current room temperature press both - and
and hold for 2 seconds. To return to time display repeat press and hold operation.
! Remember - the unit will revert to time display after Programming or Advanced Programming
Mode has been entered.
Reminder – Whilst in thermometer mode if the display fl ashes a row of bars the measured
temperature exceeds the display limit.
I) R
ESETTING THE THERMOSTAT MEMORY
Caution – Returns thermostat to factory settings: This should only be carried out should the
performance of the thermostat become erratic, this is only likely to happen as a result of severe
electro-magnetic interference such as a lightening storm.
To reset clock and re-start the thermostats micro-processor press the RESET button. After doing
this the thermostat must be re-programmed.
J) S
R
ETTING
ECORD
Event Setting
Time:
User
Factory
User
Factory
User
Factory
User
6
Time/ temp
Days 1-5
6:30
Temp. Heat:
20.0°C
Time:
Temp. Heat:
Time:
8:30
Temp. Heat:
15.0°C
Time:
Temp. Heat:
Time:
16:30
Temp. Heat:
21.0°C
Time:
Temp. Heat:
Time:
22:30
Temp. Heat:
15.0°C
Time:
Temp. Heat:
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to
products already on order provided that such alterations can be made without subsequent changes being necessary in specifi cations already agreed.