AT&T Merlin II Feature Module 2 Data Communications Manual page 73

WITH A PERSONAL
TERMINAL (PT) 510D
5-6 Data Calls with Digital Voice and Data Equipment
Programming a Data Status Button
you have a Data Status button on your voice terminal, the green light next
If
to the button goes on whenever a data call is in progress. You can program
this feature on an available button if you want to be reminded that you have
an active data call.
Follow these steps to program a Data Status button:
Type or print "Data" on the label of an available button with lights.
1
Dial #33 to enter programming mode.
2
In programming mode, the voice terminal rings every 5 seconds to remind you that you
can 't place or receive voice calls.
Touch the button you want to program.
3
Dial *93.
4
Dial the intercom number of your voice terminal.
5
Dial #00 to return to call-handling mode.
6
Data Calls
Receiving
The data stand automatically answers any incoming data calls, such as
electronic mail messages, when:
• Your computer or data terminal is on.
and
The Data Terminal Ready lead is on.
•
If you use the Do Not Disturb feature to keep voice calls from ringing at your
voice terminal, the data stand can still answer incoming data calls.
You see a message like this on your screen when you receive a data call:
INCOMING CALL - ANSWERED
If the caller disconnects, you see this message:
With the PT 510D, you can type the number or use the Directory feature to
place a data call. For information on setting up Directory entries, see the
PT
510D User's Guide.
Follow the appropriate procedure below to place an internal data call.
Placing a Data Call Using the Keyboard
From the PHONE or DATA screen press the DATA ON/OFF block; or
1
from the DATA screen press the Break key on the keyboard.
When the prompt appears, type an asterisk, then the intercom
2
:
DIAL
number or data hunt group number.
For example, if data hunt group 871 connects you to your in-house host
computer, type:
*871