Data Status Buttons For Digital Voice Terminals - AT&T Merlin II Feature Module 2 Data Communications Manual

Data Status Buttons for Digital Voice Terminals

PROCEDURE FOR
PROGRAMMING DATA
BUTTONS
If a digital voice terminal has a Data Status button, the green light next to the
button goes on whenever a data call is in progress. The light is off whenever
the digital data endpoint is idle.
Users can program Data Status buttons on their own voice terminals by
following the instructions given in Section 5, "Using Data Equipment for
Calls." If you prefer to assign this feature yourself, perform the procedure
below.
Use the Centralized Programming procedure dexrived in Section 2 of the
MERLIN II System Manual or follow the steps below to assign this feature to
buttons on digital voice terminals.
Label an available button Data.
1
Dial #33 enter programming
2 to
In programming mode, the voice terminal rings every 5 seconds to remind you that you
can't place or receive calls.
Touch the button you want to program.
3
D i a l
*93.
4
D i a l
the intercom number of the voice terminal.
5
# 00 to return the voice terminal to call-handling mode.
D i a l
6
mode.
Data Status Buttons for Digital Voice Terminals 4-9