AT&T Merlin II Feature Module 2 Data Communications Manual page 67

PROCEDURE FOR
PROGRAMMING AN AUTO
ANSWER-ALL BUTTON
4-12 Simultaneous Voice and Data at Analog Voice Terminals
Check your Station Configuration Forms to see which voice terminals are
3
not BIS/HFAI models. Touch both Auto Intercom buttons for each voice
terminal that has the Simultaneous Voice and Data feature until the green
lights show the appropriate code:
Green light on = BIS or HFAI voice terminal
Green light off = membrane-button voice terminal
If you have other data options to administer, go to step 2 of the procedure
4
for the option you are administering. If not, leave administration mode.
Analog voice terminals with the Simultaneous Voice and Data feature must
have an Auto Answer-All button so that incoming calls can be answered
automatically by the modem. Use the Centralized Programming procedure
described in Section 2 of the MERLIN II System Manual or follow the steps
below to program buttons.
Label the button Auto Answer-All.
1
Slide the T/P switch to P.
2
In programming mode, the voice terminal rings every 5 seconds to remind you that you
can 't place or receive calls.
Touch the button you want to program.
3
Dial *75.
4
Slide the T/P switch to the center position.
5