Getting Things Ready - Electrolux EOG 7330 Owner's Manual

INSTALLATION INSTRUCTIONS
·
This appliance must not be installed on a wooden
base.
·
The dimensions
circulation around the unit within the cabinet,
ensuring compliance with BS EN30.

GETTING THINGS READY

PREPARING CABINET FOR FITTING OVEN
·
Make sure the cabinet is the correct size for the
appliance to be fitted (Ref. Fig. 4).
·
If the size is between 605-610mm, then the cabinet
should be modified so that at the screw fixing points
the recommended dimension of at least 600-605mm
is maintained. The modification should ideally be
localised to ensure that after screw fitment the oven
is securely fixed into position.
·
The adjacent cabinets must be stable and firmly
secured to the wall or floor.
arrangements to ensure the work surface below
which the oven will rest is level.
·
Mark the centre of the aperture into which the
appliance is to be fitted onto the plinth board.
·
Remove the plinth board from in front of the
cabinets.
·
Cut the required ventilation slot in the plinth as
detailed in Fig.5.
·
Drill two pilot screw holes into the sides of the
adjacent cabinets, in the position indicated by Fig. 4.
·
Fit the appliance mounting brackets using the two
holes indicated in Fig. 6 to the adjacent cabinets
(Ref. Fig.4 & 7).
·
Check that the mounting brackets are level. They
can be adjusted if necessary by using the extra
holes at the ends of the brackets.
brackets are level, drill a pilot hole through the
central hole in the bracket and fit the remaining
screw.
given provide adequate
If necessary, make
Once the
NOTES
air
Fig.4
Fig.5
Fig. 6
Fig.7
34