Battery Saver™(Sleep Mode); Min Max Avg Record Mode - Fluke 233 User Manual

Battery Saver™(Sleep Mode)
The Meter powers-down (Sleep mode) if there is no
function change, range change, or button push for 20
minutes. The lowest power drain occurs when the display
module is docked with the Meter base. With the display
module removed from the Meter base, the power drain is
more because the radios are turned on.
To wake up the Meter, push a button or turn the function
switch.
To disable the Sleep mode, hold down the  button
while turning the Meter on. The Sleep mode is always
disabled in the MIN MAX AVG mode.

MIN MAX AVG Record Mode

The MIN MAX AVG record mode records the minimum
and maximum input values, and calculates an average of
all measurements. Each new high or low measurement
causes the Meter to beep.
Set the Meter to the measurement function and
range.
Push  to enter MIN MAX AVG mode.
 and MAX are shown and the highest
measurement detected since  is shown.
Push  to step through the low (MIN), average
(AVG), and present measurements.
True-rms Remote Display Digital Multimeter
Battery Saver™(Sleep Mode)
To pause MIN MAX AVG record mode, push .
 is shown. A pause does not erase recorded
MIN MAX AVG measurements.
To continue the MIN MAX AVG record mode, push
 again.
To exit and erase recorded measurements, push
 for at least one second or turn the function
switch.
13