Chassis Intrusion Connector; Digital Audio Connector - Asus P5P800-VM Manual

5. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or
switch cable to this connector. The chassis intrusion sensor or
switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as
a chassis intrusion event.
By default, the pins labeled "Chassis Signal" and "Ground" are
shorted with a jumper cap. Remove the jumper caps only when you
intend to use the chassis intrusion detection feature.
P5P800-VM Chassis Intrusion Connector
6. Digital Audio connector (4-1 pin SPDIF_OUT)
This connector is for the S/PDIF audio module to allow digital sound
output. Connect one end of the S/PDIF audio cable to this connector
and the other end to the S/PDIF module.
P5P800-VM Digital audio connector
The S/PDIF out module is purchased separately.
1-30
®
®
CHASSIS
(Default)
SPDIF_OUT
Chapter 1: Product introduction