Asus P5P800-VM Manual page 67

DRAM RAS# Precharge [4 Clocks]
Controls the idle clocks after issuing a precharge command to the DDR
SDRAM. Configuration options: [4 Clocks] [3 Clocks] [2 Clocks]
DRAM RAS# to CAS# Delay [4 Clocks]
Controls the latency between the DDR SDRAM active command and
the read/write command. Configuration options: [4 Clocks] [3 Clocks]
[2 Clocks]
DRAM Precharge Delay [8 Clocks]
Sets the RAS Activate timing to Precharge timing.
Configuration options: [8 Clock] [7 Clocks] [6 Clocks] [5 Clocks]
DRAM Burst Length [8 Clocks]
Sets the DRAM Write Recover Time.
Configuration options: [4 Clocks] [8 Clocks]
Performance Acceleration Mode [Auto]
Enables or sets the performance acceleration mode. When Enabled, the
CPU to memory latency is minimized to boost performance. Configuration
options: [Enabled] [Auto]
Setting to Enabled may cause the system to become unstable! If this
happens, revert to the default setting [Auto].
DRAM Idle Timer [Auto]
Sets the DRAM idle timer. Configuration options: [Infinite] [0T] [8T] [16T]
[64T] [Auto]
DRAM Refresh Rate [Auto]
Sets the DRAM refresh rate. Configuration options: [Auto] [15.6 uSec] [7.8
uSec] [64 uSec] [64T]
Graphics Adapter Priority [AGP/Int-VGA]
Allows you to select the graphics adapter to use as primary boot device.
Configuration options: [Internal VGA] [AGP/Int-VGA][AGP/PCI] [PCI/AGP]
[PCI/Int-VGA]
Graphics Aperture Size [ 64MB]
Allows you to set the size of mapped memory for the AGP graphic data.
Configuration options: [16MB] [32MB] [64MB] [128MB] [256MB]
MPS Revision [1.4]
Sets the MPS revision version. Configuration options: [1.1] [1.4]
ASUS P5P800-VM 2-21