Dc Power - Clarke Power FG2000 Operation & Maintenance Instructions Manual

DC POWER

For charging car batteries only
CAUTION: MAKE CONNECTIONS TO THE BATTERY AFTER STARTING THE
ENGINE.
1. Start the generator.
2. Connect the battery charging
leads to the generator.
3. Connect the battery charging
leads to the battery.
• Clamp the red wire to the
positive (+) terminal and the
black wire to the negative (-)
terminal of the battery. Do not
reverse these positions.
WARNING: TO PREVENT THE POSSIBILITY OF CREATING A SPARK NEAR THE
BATTERY, DISCONNECT THE CABLE TO THE GENERATOR FIRST AND THEN
DISCONNECT THE BATTERY.
WARNING: AFTER YOU HAVE CHARGED THE BATTERY, ALWAYS
DISCONNECT THE NEGATIVE LEAD FIRST.
DC OVER LOAD PROTECTOR
If the DC overload protector
activates, wait for a few minutes and
then press the reset button shown on
the right.
16