Table of Contents
Advertisement
Preparation
Antennas
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections
that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector,
plug it into the antenna terminal at the rear of the 1V set.
1. A 75-ohm system is generally a round cable with F-type connector
that can easily be attached to a terminal without tools (Commercially
available).
2. A 300-ohm system is a flat "twin-lead" cable that can be attached
to a 75-ohm terminal through a 300/75-ohm adapter (Commercially
available).
r
F-type connector
----I . ••,
75-ohm coaxial cable (round)
-
3 00-ohm twin-lead cable (flat)
NOTICE
F-type connector should be finger-tightened only.
When connecting the RF cable to the 1V set, do not tighten F-type
connector with tools.
If tools are used, it may cause damage to your 1V set. (The breaking
of internal circuit, etc.)
~
$A.'
F -type connector
~A~~\
75-ohm coaxial cable
ANTICABLE
II
Home Antenna
7S-ohm coaxial cable (round)
terminal (7S-ohm)
"---_......_----[jJi
-~I==
Coaxial cable
(commercially available)
I
()(
I
3OOflS-ohm adapter
3QO-ohm twin-lead cable
(flat)
(commercially available)
....__...
~--====.
J
~:m~n:UT~
---"'i--"+
'0
300-ohm twin-lead cable
(commercially available)
~IIIIII_IIIIIIIIII
E=
To TV antenna
lor
75-ohm coaxial cable
'"""'_.............................- - - . . .
terminal
'Ys-ohm coaxial cable (round)
UHF
~
300-ohm
VHF
ANTENNA
twin-lead cable
ANTENNA
®
VHF/UHF antenna
@
Separate VHF/UHF
antenna
CD
Cable without a CATV
converter
@
Combination VHF/
UHF antenna
Connecting Antenna Cable
• Connect the antenna cable to the TV using one of the methods in the illustration as shown
<CD,
®,
@
or
@).
Home Antenna
terminal (7S-ohm)
..... Cab__.le.. TVioile.a.. d-.. 'n
~ "~I==-
Coaxial cable
(commercially available)
Installing Batteries in the Remote Control Unit
If the remote control fails to operate 1V functions, replace the batteries in the remote control unit.
1 Open the battery cover.
2 Insert two "AA" size batteries
3 Close the battery cover.
(supplied with the product).
j
• Place the batteries with their terminals
corresponding to the (
+)
and ( - )
indications in the battery compartment.
Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.
• Do not mix batteries of different types. Different types of batteries have different characteristics.
• Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage
in old batteries.
• Remove batteries as soon as they are worn out. Chemicals that leak from batteries that come in contact with skin can cause a
rash. If you find any chemical leakage, wipe thoroughly with a cloth.
• The batteries supplied with this product may have a shorter life expectancy due to storage conditions.
• If you will not be using the remote control unit for an extended period of time, remove batteries from it.
9
Hide quick links:
Advertisement
Table of Contents
