Aeb With The Iso Speed - Canon EOS 1D MkII Instruction Manual

AEB with the ISO Speed

Set the ISO speed that is to be the standard AEB exposure. For
example, if you want AEB with ±1 stop and ISO 200, 400, and 800, set
the ISO speed to 400.
¡
AEB shooting (by changing the shutter speed/aperture or ISO speed)
cannot be used with flash photography and bulb exposures.
¡
AEB shooting is possible only within the settable shutter speed range
(1/8000 - 30 sec.), aperture range, and ISO speed range (100 - 1600).
It is not possible with ISO 50 and 3200 even if the ISO speed extension
is [On].
¡
If you use C.Fn-06-2 to set the exposure setting increment to 1/2 stop,
AEB shooting with the ISO speed will not be possible.
¡
In the continuous shooting mode, holding down the shutter button will
take all three bracketed shots continuously, then the shooting will stop
automatically (except during mirror lockup).
¡
When AEB is used with the self-timer, the three bracketed shots will be
taken in succession after the 2- or 10-second self-timer delay.
¡
If the drive mode is set to single shooting, press the shutter button three
times to take the three AEB shots.
¡
AEB can be combined with exposure compensation.
¡
During AEB shooting, the <
g
< > icon on the LCD panel will blink.
94
Set the AEB amount.
¡Hold down the <
buttons simultaneously and turn the
5
< > dial.
¡The diagram on the left shows an AEB
amount of ±1 stop centering on the
standard exposure level. The AEB
amount (1.0), the AEB range <
i
and the <
¡The shooting operation will be the
same as AEB shooting while changing
the shutter speed or aperture.
w
> icon in the viewfinder and the <
E Q
> and <
> icon will be displayed.
h
>
N
>,
> or