Aeb With The Iso Speed - Canon EOS 1Ds Mark II Instruction Manual

AEB with the ISO Speed

Set the ISO speed that is to be the standard AEB exposure. For
example, if you want AEB with ±1 stop and ISO 200, 400, and 800, set
the ISO speed to 400.
¡
AEB shooting (by changing the shutter speed/aperture or ISO speed)
cannot be used with flash photography and bulb exposures.
¡
AEB shooting is possible only within the settable shutter speed range (1/
8000 - 30 sec. ), aperture range, and ISO speed range (100 - 1600). It is
not possible with ISO 50 and 3200 even if the ISO speed extension is
[On].
¡
If you use C.Fn-06-2 to set the exposure setting increment to 1/2 stop,
AEB shooting with the ISO speed will not be possible.
¡
In the continuous shooting mode, holding down the shutter button will
take all three bracketed shots continuously, then the shooting will stop
automatically (except during mirror lockup).
¡
When AEB is used with the self-timer, the three bracketed shots will be
taken in succession after the 2- or 10-second self-timer delay.
¡
If the drive mode is set to single shooting, press the shutter button three
times to take the three AEB shots.
¡
AEB can be combined with exposure compensation.
¡
During AEB shooting, the <
g
< > icon on the LCD panel will blink.
94
Set the AEB amount.
¡Hold down the <
buttons simultaneously and turn the
5
< > dial.
¡The diagram on the left shows an AEB
amount of ±1 stop centering on the
standard exposure level. The AEB
amount (1.0), the AEB range <
i
and the <
¡The shooting operation will be the
same as AEB shooting while changing
the shutter speed or aperture.
w
> icon in the viewfinder and the <
E Q
> and <
> icon will be displayed.
h
>
N >,
> or