The contents of this document are provided in connection with Avenview Inc. ("Avenview") products. Avenview makes no representations or warranties with
respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at any
time without notice. No license, whether express, implied, or otherwise, to any intellectual property rights is granted by this publication. Except as set forth in
Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products
4k displayport extender over
single sc fiber optic cable (20 pages)
Summary of Contents for Avenview FO-HDMI-1000M-EMI
Page 1
No license, whether express, implied, or otherwise, to any intellectual property rights is granted by this publication. Except as set forth in Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products...
Removal, installation, and set-up service charges. Safety Instructions The Avenview FO-HDMI-1000M-EMI, HDMI Extender SET over Single Fiber Optic, has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipment’s, the FO-HDMI-1000M-EMI should be used with care. Read the following safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit.
Introduction Avenview FO-HDMI-1000M-EMI optical HDMI extension module, is designed to let digital flat panel display extend over 1000 meters away from host based on HDMI standard by optical transmission technology. Its small package and transmit up to four video and one low-speed lane, while simultaneously receiving one low-speed signal, all on one multimode fiber.
Installation Avenview FO-HDMI-1000M-EMI is composed of a Transmitter converting the graphic signal of a computer to optical and Optical Fiber propagating the optical signal and Receiver supplying electrical signal to monitor converted from the optical signal to electrical signal. The Transmitter should be connected to computer and the Receiver should be connected to a monitor.
100 ~ 240V 5V 2A DC Dimensions (L x W x H) 10.7” x 1.2” x 0.5” Environmental Operating Temperature 32˚ ~ 104˚F (0˚ to 40˚C) Storage Temperature -4˚ ~ 140˚F (-20˚ ~ 60˚C) Relative Humidity 20~90% RH (no condensation) 2.1 Case Dimensions www.avenview.com...
2.4 Optical Fiber Cable The construction of 4 Optical Fibers and 4 Copper wires cable shall be in accordance with Figure and Table below: www.avenview.com...
Page 9
Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of...
Need help?
Do you have a question about the FO-HDMI-1000M-EMI and is the answer not in the manual?
Questions and answers