4k displayport extender over
single sc fiber optic cable (20 pages)
Summary of Contents for Avenview FO-HDSDI-SET
Page 1
No license, whether express, implied, or otherwise, to any intellectual property rights is granted by this publication. Except as set forth in Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products including, but not limited to, the implied warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right.
However, like all electronic equipments, the FO-HDSDI-SET should be used with care. Read the following safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit.
Introduction The FO-HDSDI-SET is an ideal and economic solution designed for transmission of multi-rate SDI video, with embedded audio and metadata over a multi-mode optical fiber cable. The transmitter module (FO-HDSDI-S) receives one HD-SDI electrical input, perfectly converts SMPTE 292M, SMPTE 259M, or DVB-ASI electrical SDI signal to multi-mode optic SDI signals.
Automatic re-clocked / Manual bypass (optional upon request) HD/SDI Input signal detection Easy installation Package Contents Before you start the installation of the converter, please check the package contents. FO-HDSDI-SET Power Adapter (+5VDC) User’s Manual Before Installation Put the product in an even and stable location. If the product falls down or drops, it may cause an injury or malfunction.
TRANSMITTER RECEIVER Section 2: Installation Follow these instructions for installation of FO-HDSDI-SET: 1. Connect a camera or other HD/SD-SDI device to transmitter of FO-HDSDI-SET www.avenview.com...
Page 7
2. Connect devices equipped with HD/SD-SDI inputs (e.g. monitors or video processors) to receiver FO-HDSDI-SET 3. Plug power adapter to 5V DC power jack of FO-HDSDI-R & FO-HDSDI-S www.avenview.com...
4.3” x 1.6” x 1.2” (L x W x H) 5V 4A DC 5 Watts (max) 0~40°C [32~104°F] -20~60°C [-4~140°F] 20~90% RH [no condensation] www.avenview.com FO-HDSDI-R Receiver (RX) 75 [HD-SDI] up to 125m (410ft) [SD-SDI] up to 300m (1000ft) 1 x Optical LC (SDI)
Page 10
While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of...
Need help?
Do you have a question about the FO-HDSDI-SET and is the answer not in the manual?
Questions and answers