Table of Contents
Advertisement
Quick Links
VGA to DVI Extender over Fiber SET
Model #: FO-VGA-DVI
© 2011 Avenview Inc. All rights reserved.
The contents of this document are provided in connection with Avenview Inc. ("Avenview") products. Avenview makes no representations or warranties with
respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at any
time without notice. No license, whether express, implied, or otherwise, to any intellectual property rights is granted by this publication. Except as set forth in
Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products
including, but not limited to, the implied warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right.
Reproduction of this manual, or parts thereof, in any form, without the express written permission of Avenview Inc. is strictly prohibited.
www.avenview.com
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Avenview FO-VGA-DVI
Summary of Contents for Avenview FO-VGA-DVI
- Page 1 No license, whether express, implied, or otherwise, to any intellectual property rights is granted by this publication. Except as set forth in Avenview Standard Terms and Conditions of Sale, Avenview assumes no liability whatsoever, and disclaims any express or implied warranty, relating to its products including, but not limited to, the implied warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right.
-
Page 2: Table Of Contents
2.1 Electrical & Optical Specifications ....................8 2.1.1 Electrical Specifications ......................8 2.1.2 Optical Specifications ......................8 2.2 Connector PIN Assignment ......................9 2.2.1 Input Connector ........................9 2.2.2 Output Connector ....................... 10 2.2.3 Optical Cable Information ....................11 www.avenview.com... -
Page 3: Section 1: Getting Started
Removal, installation, and set-up service charges. Safety Instructions The Avenview FO-VGA-DVI, VGA to DVI Extender over Fiber Optic has been tested for conformity to safety regulations and requirements, and has been certified for international use. However, like all electronic equipment’s, the FO-VGA-DVI should be used with care. Read the following safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit. -
Page 4: Regulatory Notices Federal Communications Commission (Fcc)
Introduction Avenview FO-VGA-DVI, VGA to DVI Extender over Fiber SET lets you extend VGA signal and convert it to DVI up to 500 meters (1650 feet) at 1920 x 1200 away from host by TMDS analog signal transmission with only 1 SC Type fiber optic cable. -
Page 5: Installation
Installation The FO-VGA-DVI Transmitter should be connected to the computer’s VGA Port and the Receiver (FO-DVI-1000M-EMI-R) should be connected the DVI Port of the digital display device. Avenview FO-VGA-DVI and FO-DVI-1000M-EMI-R Receiver is designed to be used with SC type standard optical cable (Multi-Mode optical fiber: 50/125, 62.5/125um). -
Page 6: Troubleshooting
Check the maximum resolution range of the graphics card. Caution 1. Do not put heavy object on top of the FO-VGA-DVI. It may cause product malfunction. 2. Put the product on even and stable location. If the product falls down or dropped, it may get damaged. -
Page 7: Section 2: Specifications
Stresses greater than those listed under “Environmental Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operations section for extended periods of time may affect reliability. www.avenview.com... -
Page 8: Electrical & Optical Specifications
(P1TX4B-SX4V-01) RMS Spectral Width Transmitter module of FO-VGA-DVI includes VCSEL (Vertical Surface Emitting Laser Diode) with 850 nm invisible laser radiation. DO NOT view directly at laser module of Transmitter or the end of the other side of optical cable connected to Transmitter with optical instrument. -
Page 9: Connector Pin Assignment
2.2 Connector PIN Assignment 2.2.1 Input Connector Signal Assignment Signal Assignment Green Ground Blue Ground Ground Ground H Sync Red Ground V Sync Green Ground Blue Ground www.avenview.com... -
Page 10: Output Connector
Signal Assignment T.M.D.S. optical output Signal Signal Signal Assignment Assignment Assignment CH 2- CH 1- CH 0- CH 2+ CH 1+ CH 0+ CH2 Ground CH1 Ground CH0 Ground CLK Ground Ground CLK+ CLK- Ground Ground Ground Ground Ground www.avenview.com... -
Page 11: Optical Cable Information
2.2.3 Optical Cable Information www.avenview.com... - Page 12 Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of...
Need help?
Do you have a question about the FO-VGA-DVI and is the answer not in the manual?
Questions and answers