Passive Or Active Arming Starter Kill; Lock Pulse Duration; Engine Run Time; Idle Mode - ProStart CT-3200 Installation Manual

seconds after shutdown, Secure Lock will re-lock all Doors once more (arming the system again).
Please note that most OEM systems will not rearm the Alarm while the Engine is running, but will
lock the Doors.

Passive or Active Arming Starter Kill

The Starter Kill can be programmed to be ac
automatically). In Passive Mode, you can program it to arm automatically after 1 or 3 min.
To disarm the Starter Kill in Active or Passive Mode, the user must press and hold butt
enable Valet Mode). The Parking Lights will flash twice. If the Door Locks option was installed, this
will also unlock the Doors. To arm the Starter Kill in Active or Passive Mode, the user must press
Ι
and hold button . The Parking Lights will flash once. (If the Door Locks option was installed, this
will also lock the Doors). In Passive Mode, the system will automatically arm itself 1 or 3 minutes
after the Engine is shut down.

Lock Pulse Duration

The Door Lock pulse dur
default), 4-sec.
LOCK
pulses (used for double-pulse disarm/unlock systems).
UNLOCK

Engine Run Time

In mode the Mod ule can be programmed to keep the Engine running for 4, 15 (default), or 25
GAS
minutes. In mode the Module can be set to 9, 20 (default) or 30 min.
DIESEL

Idle Mode

When progra mmed, this option allows the user to engage the remote starter to take over the
vehicle while it is already running. This option will keep the vehicle running for the pre-programmed
run time, or until it is shut down.

Resetting the Module (without the plug-in valet)

Resetting the Module is not a required process. Most of the tim
Module by fixing the issue directly at the root of the cause.
To reset the Module, without using the plug-in Valet butt
1. FLASH the hood pin switch.
2. In ten seconds or less, press the Brake Pedal six times.
3. The Parking Lights will flash 8 times confirming the Reset.
On some vehicles, such as, BMW, and certain
the key in the Ignition
Pedal–manually jumping 12Volts, with a fused test lead, at the Brake Pedal switch.

Resetting the Module (with the use of the plug-in valet)

The system is equipped with a reset function that allows the installer to eras
and return all programmed Options to the factory default values.
To reset the Module:
1. FLASH the Hood pin switch.
2. Press the Valet Button (if the plug-in valet was installed) 6 times or more, until the
Parking Lights start to flash.
3. The Parking Lights will flash 8
P. 12
ation can be programmed to give 7/10-sec.
and pulses, or for a 7/10-sec.
UNLOCK
position, will not work and therefore you will need to hot wire the brake
ON
times confirming the Reset.
tive (will not arm automatically) or passive (will arm
LOCK
on:
Table 6
Volkswage ns, etc., pressing the Brake pedal without
Table 7
and pulses (by
LOCK UNLOCK
pulse and two 1/4 -second
e, you can avoid resetting the
e all Transmitter codes
Installation Guide CT-3200
Ι
on (or