Advertisement
CARE AND MAINTENANCE
CHANGING THE LIGHT BULBS
Note: All parts removed during this process must be saved and refitted
after the bulb has been replaced. Before removing the LED light, unplug
the wine cooler from your mains supply.
Failure to do so could result in electrical shock or personal injury.
You should use an LED bulb which is of the same type as the bulb
originally supplied with the appliance.
Cleaning Your Wine Cooler
Unplug the wine cooler, and remove all bottles.
Wash the inside with a mixture of warm water and baking soda.
The solution should be approximately 2 tablespoons of baking soda to
one quart of water.
Wooden shelves do not require cleaning.
The outside of the wine cooler should be cleaned with a mild detergent
and warm water.
It may also be necessary to periodically wipe the bottom part of the
storage area, as the wine cooler is designed to retain humidity, and
condensation may collect there.
Maintenance of Your Wine Cooler
Power Failure
Most power failures are corrected within a few hours and should not
affect the temperature of your wine cooler, as long as you minimize the
number of times that the door is opened. If the power is going to be off
for a longer period of time, you should take steps to protect the contents
of your wine cooler.
Vacation Time
During long absences, remove all of the bottles; unplug your wine cooler,
clean it, and leave the door open slightly to avoid the possible formation
of condensation or mould.
Moving Your Wine Cooler
Remove all of the bottles.
Securely tape down all loose items inside of your wine cooler.
Turn the levelling feet fully up to the base to avoid damage.
Tape the doors shut.
Make sure that the wine cooler remains in the upright position during
transportation.
11
Troubleshooting
Troubleshooting
You can solve many common wine cooler problems easily, saving
yourself the cost of a possible service call. Try the hints below to
see if you can solve the problem before calling the Baumatic Service
Department.
TROUBLESHOOTING GUIDE
PROBLEM
Wine cooler does
Not plugged in.
The circuit breaker has tripped or a fuse has
not operate.
blown.
The temperature control is not set correctly.
Wine cooler is
The external environment may require a lower setting.
not cold enough.
The door has been opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The wine cooler does not have the correct ventilation
clearances to the rear or side of the wine cooler.
The room temperature is hotter than normal.
A large amount of warm wine has been added to the
Compressor turns
wine cooler.
on and off frequently
The door has been opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The wine cooler does not have the correct ventilation
clearances to the rear or side of the wine cooler.
The light does
The home circuit breaker or fuse has tripped.
The wine cooler is unplugged.
not work.
The LED light has burnt out(see maintenance section
for the replacement procedure).
The light bulbs have been switched off with the
light bulb ON/OFF switch.
12
POSSIBLE CAUSE
Advertisement
