Advertisement
Before using your Baumatic wine cooler
Avoid locating the appliance in a location that gets damp. Too much
moisture in the air will cause frost to form more quickly on the evaporator.
Plug the appliance into an exclusive, properly installed and earthed wall
socket. Do not under any circumstances cut or remove the earth wire
from the power cable. Any questions concerning the electrical connection
should be directed towards a certified electrician or the Baumatic Technical
Department.
You must attach the doo r handle to the left hand side of the frame before
you start to use the wine cooler.
Improper use of the earthed plug can result in the risk of electrical
shock. If the power cable is damaged you should have it replaced by
an authorised Baumatic engineer.
Climate classification
Appropriate ambient temperature
SN
+10 to +32 degrees centigrade
N
+16 to +32 degrees centigrade
ST
+18 to +38 degrees centigrade
T
+18 to +43 degrees centigrade
7
Using your Baumatic wine cooler
IMPORTANT SAFEGUARDS
Do not store food in your wine cooler, as the interior temperature will not be
cool enough to prevent spoilage. The outside of the glass door may suffer
from condensation during the summer or if it is installed in an area of high
humidity. You can simply wipe the condensation away with a cloth.
OPERATING YOUR WINE COOLER
Before starting the wine cooler, ensure that the cabinet is level. This will
eliminate the possibility of vibration when the wine cooler is in use.
We recommend that you install the wine cooler in a place where the ambient
temperature is between +16 and +32 degrees centigrade. If the ambient
temperature falls outside of this temperature range then it may cause the
interior temperature to fluctuate. The recommended temperatures for
chilling wine are as follows:-
15-18 degrees centigrade
Red wines:
10-15 degrees centigrade
Dry/White Wines
9-10 degrees centigrade
Rose Wines
6-9 degrees centigrade
Sparkling Wines
3-6 degrees centigrade
Beverage
SETTING THE TEMPERATURE CONTROLS
The wine cooler has two cooling compartments (upper & lower) which are
independently controlled. To set the temperature you should do as follows:-
1. Connect the power cord to a properly grounded outlet. The temperature
preset at factory of each compartment is:
12 C (54 F)-Upper Compartment
6 C (43 F)-Lower Compartment
2. Set the desired cooling temperature by pressing the button
are under the Upper Compartment/Lower Compartment text on the control panel.
When you push the buttons for the first time, the LCD readout will show the
previously set temperature. The temperature will increase by 1 degree centigrade
if you push the upward arrow (
decrease by 1 degree C by pushing
If you have altered the display so that it shows in farenheit, the temperature will
increase and decrease in one farenheit steps, rather than one centrigrade steps.
these
or
) once. Conversely the temperature will
(the downward arrow) once.
8
Advertisement
