Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
INSTALLATION NOTES
1. Cut the aperture to the dimensions shown below or use the template if printed on the
packaging.
2. Invert the Hob and apply the sealing agent provided to match the outer perimeter edge.
3. If the sealing agent is a strip type, the protective covering must be removed from both sides.
Do not leave a gap in the sealing agent or overlap the thickness.
NOTE: do not use any Silicone based sealant, as this can damage the worktop surface if
repairs are required.
4. Insert the appliance into the aperture and fix in position via the clamps & screws, tightening
the screws evenly (see Fig. 1 below).
5. If the appliance is to be installed in a Leisure Accommodation Vehicle, the requirements of
EN 721 must be applied.
HOB APERTURE DIMENSIONS
MODEL
A
B
AS4.1
580 510 560 480 50
AS5.1
685 510 560 480 50
B70
580 510 560 480 40
Fig. 1
C
D
E
9
Advertisement
Table of Contents
