Media Reference Position Adjustment Mechanism - Konica Minolta A00F011 Service Manual

4. Operations
4.1.10

Media reference position adjustment mechanism

• The edge guide plate can be moved to allow the print start reference position for the
media to be adjusted.
1. Through a hole in the media lift plate on top of the tray, loosen two screws that
secure the edge guide plate.
2. Accessing the tray from its bottom surface, loosen two screws that secure the refer-
ence position adjusting plate.
3. Slide the reference position adjusting plate as necessary as indicated on the scale.
4. From the bottom surface of the tray, tighten the two screws that secure the refer-
ence position adjusting plate.
5. Through the hole in the media lift plate on top of the tray, tighten the two screws
that secure the edge guide plate.
Media lift plate
Reference position
adjusting plate
4.1.11 Media misfeed detection control
• If the media feed sensor is not activated within a predetermined period of time after a
media feed sequence has been started, the main body determines that there is a media
misfeed. It then displays a media misfeed message on the panel.
• The media misfeed display can be reset by opening and closing any door.
10
Reference position adjusting plate fixing screws
Theory of operation Ver. 1.0 Nov. 2007
4138to2125c0
Adjustment scale
4138to2123c0
Edge guide plate fixing
screws