Image Stabilization Control Execution Request - Konica Minolta A00F011 Service Manual

Theory of operation Ver. 1.0 Nov. 2007
21.1.4

Image stabilization control execution request

• A request for execution of the complete correction control, simplified correction control,
or individual registration control is made at the following timing.
Stabilization request timing
When a new IU is detected
When a other used IU is
Upon
detected
replace-
ment of unit
When the transfer belt unit is
replaced
When the power switch is
turned ON
When there is a great change
in environmental conditions
from those when the last sta-
bilization sequence was exe-
cuted.
By main
body status
When there is a temperature
change inside the PH unit
At the end of a print cycle of
given conditions
When a malfunction is reset
User When quality menu/calibra-
selection tion/AIDC process is selected
*1: Since the main body is not provided with a function that detects a new transfer belt unit,
quality menu/calibration/AIDC process must be selected and complete correction con-
trol executed whenever the unit has been replaced with a new one.
When the power switch is
turned ON
When the front/right door is
*1
closed
Power the switch is turned
ON
Power the switch is turned
ON/When the front/right door
is closed/At the end of a job/
When the sleep mode is
deactivated
When the front/right door is
closed/At the end of a job/dur-
ing a job/When the sleep
mode is deactivated
At the end of a job
When the power switch is
turned ON
When quality menu/calibra-
tion/AIDC process is selected
21. Image stabilization control
Stabilization request
detection timing
Execution processing
Complete correction
control
Complete correction
control
Depending on each condi-
tion
Complete correction
control
individual registration con-
trol
Simplified correction
control
Complete correction
control
Complete correction
control
85