Baumatic BDW2SS Instruction Manual page 31

BAUMATIC BDW2W / BDW2SS
BE CAREFUL WHILE YOU ARE
LEVELLING YOUR DISHWASHER
IN PLACE – IT COULD TIP OVER
AND INJURE YOU!
CONSULT THE FIGURE BELOW
FOR HELP!
THE REAR FEET CAN BE ADJUSTED FROM THE FRONT OF THE DISHWASHER BY TURNING THE SCREWS ON THE LEFT
AND RIGHT HAND SIDES OF THE CABINET. TO ADJUST THE FRONT FEET, USE A WRENCH / SPANNER AND TURN THE
FRONT FEET UNTIL THE DISHWASHER IS LEVEL (PLEASE SEE 'REMARK B' IN THE ABOVE FIGURE).
WHEN YOU ROTATE THE ADJUSTER POLE CLOCKWISE, THE BACK FOOT WILL DRIVE UP THE DISHWASHER.
k) THE DISHWASHER MUST NOW BE SECURED IN
PLACE
. THERE ARE TWO WAYS TO DO THIS, DEPENDING ON YOUR TYPE OF WORK
SURFACE. REMEMBER THAT YOUR DISHWASHER'S WEIGHT MUST REST ON ITS FEET.
FASTENINGS AT ITS TOP ARE TO GIVE STABILITY AND WILL PREVENT IT FROM TIPPING
FORWARD:
NORMAL WORK SURFACE - SECURE TO THE WORK SURFACE'S UNDERSIDE BY USING TWO
WOODSCREWS ENSURING THAT THE DISHWASHER CAN OPEN AND CLOSE COMFORTABLY.
MARBLE OR GRANITE WORK TOP – FOR THESE WORKTOPS, YOU WILL NOT BE ABLE TO SECURE
THE TOP OF THE DISHWASHER TO THE UNDERSIDE OF THE SPECIAL WORK SURFACE. BECAUSE OF
THIS, YOU WILL HAVE TO SECURE THE BRACKET TO THE SIDE PANELS OF THE DISHWASHER
CABINET AND SECURE THE DISHWASHER TO THE FURNITURE HOUSING. PUT THE RUBBER CAP
OVER THE SCREW.
NOTE: DO NOT PUT ANY WEIGHT FROM THE DISHWASHER ON THESE SCREWS – ENSURE
YOUR DISHWASHER'S WEIGHT RESTS ENTIRELY ON ITS FEET.
(PLEASE SEE 'REMARK A' IN THE ABOVE FIGURE).
31
dishwasher user manual 31
THE