Kenmore 3052 - 24 in. Manual Clean Wall Oven Use And Care Manual page 16

General Care & Cleaning
Hinge
support
e lever hook
Removing and Replacing the Oven Door
The door is heavy. For safe, temporary storage, lay the door flat with the
inside of the door facing down.
Lock engaged for door
removal =Figure 1
HING_ SLOT =Door removed
from the oven
Figure 2
Hinge lever
Lock in normal position
Figure 3
To Remove Oven Door:
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the hinge lever
hooks (Figure 1).You may have to apply a little downward pressure on the door to pull
the locks fully over the hinge lever hooks.
3. Grab the door by the sides and pull the bottom of the door up and toward you to
disengage the hinge supports. Keep pulling the bottom of the door toward you while
rotating the top of the door toward the range to completely disengage the hinge levers
(Figure 2).
4. To clean oven door, follow the instructions provided in the General Care & Cleaning
table.
To Replace Oven Door:
1. Grab the door by the sides; place the hinge supports in the hinge slots. Open the door
to the fully opened position.
2. Disengage the lock from the hinge lever hooks on both sides (Figure 3).
Note: Make sure the hinge supports are fully engaged before unlocking the hinge levers.
3. Close the oven door.
Special Door Care Instructions
Most oven doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are fully in place.
2. Do not hit the glass with pots, pans, or any other object.
3. Scratching, hitting, jarring or stressing the glass may weaken its structure causing
an increased risk of breakage at a later time.
Changing the Oven Light
On some models an interior oven light will turn automatically when the oven door is
opened. The oven light may be turned on when the door is closed by pushing oven
light switch located on the control panel. On some models, the lamp is covered with
a glass shield held in place by a wire holder. THE GLASS SHIELD MUST BE IN
PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with 40-watt appliance bulb only.
4. For models with glass shield, press holder on one side to release glass shield,
change bulb and be sure to replace the glass shield.
16