Belkin F1PI210ENau User Manual page 49

Appendices
Network Connection
Problems
Cannot ping the • Verify that the IP addresses are properly
VoIP Router from configured. For most applications, you
the attached LAN, should use the VoIP Router's DHCP function
or the VoIP Router to dynamically assign IP addresses to
cannot ping any hosts on the attached LAN. However, if you
device on the manually configure IP addresses on the
attached LAN LAN, verify that the same network address
(network component of the IP address) and
subnet mask are used for both the VoIP
Router and any attached LAN devices.
• Be sure the device you want to ping (or
from which you are pinging) has been
configured for TCP/IP.
• Disable any installed Firewalls
Troubleshooting
Symptom Action
Management Problems
Cannot connect • Be sure to have configured the VoIP Router
using the Web with a valid IP address, subnet mask, and
browser default gateway.
• Check that you have a valid network
connection to the VoIP Router and that the
port you are using has not been disabled.
• Check the network cabling between the
management station and the VoIP Router.
• Disable any installed Firewalls.
• Disable any proxies
Forgot or lost • Press the Reset button on the rear panel
the password (holding it down for at least 20 seconds) to
restore the factory defaults. Note: All
settings will need to be re-entered – this
option wipes all settings and restore the unit
back to the factory defaults.
94
Appendices
Appendix B Cables
Ethernet Cable
Caution: Do not plug a phone jack connector into an RJ-45 port.
For Ethernet connections, use only twisted-pair cables with RJ-45
connectors that conform to FCC standards.
Specifications
Cable Types and Specifications
Cable Type
10BASE-T Cat. 3, 4, 5 100-ohm UTP
100BASE-TX Cat. 5 100-ohm UTP
Max. Length Connector
100 m (328 ft) RJ-45
100 m (328 ft) RJ-45
95
1
2
3
4
5
6
7