Appendices - Belkin F1PI210ENau User Manual

Appendices

Appendix A1 Troubleshooting
After completing hardware setup by connecting all your network
devices, you should automatically be able to connect to the VoIP
ADSL Wireless Router by entering 10.1.1.1 into your Internet browsers
address bar.
Should this not work please first determine how your ISP issues
your IP address. Many ISPs issue these numbers automatically using
Dynamic Host Configuration Protocol (DHCP). Other ISPs provide
a static IP address and associated numbers, which you must enter
manually. How your ISP assigns your IP address determines how you
may need to change the configuration of your computer as per the
steps below.
TCP/IP Configuration
To access the Internet through the VoIP Router, you must configure
the network settings of the computers on your LAN to use the same IP
subnet as the VoIP Router. The default network settings for the ADSL
Router are:
IP Address: 10.1.1.1 Subnet Mask: 255.255.255.0
Note: These settings can be changed to fit your network requirements,
but you must first configure at least one computer to access the VoIP
Router's web configuration interface in order to make the required
changes.
Configuring Your Computer in Windows 2000
DHCP IP Configuration
1. On the Windows desktop, click Start/Settings/Network and
Dial-Up Connections
2. Click the icon that corresponds to the connection to your VoIP
Router
3. The connection status screen will open. Click Properties
86
Appendices
1. Double-click Internet Protocol (TCP/IP)
2. If "Obtain an IP address automatically" and "Obtain DNS server
address automatically" are already selected, your computer is
already configured for DHCP. If not, select these options and then
click ok and then ok again, or click Cancel to close each window
87
1
2
3
4
5
6
7