Table of Contents
Advertisement
Compo-
No.
nent
1
Port
Selection
Switches
2
Port LEDs
The Port LEDs are built into the Port Selection Switches. The left
ones are the On Line LEDs; the right ones are the Selected Port
LEDs:
3
Reset
Pressing this switch in performs a system reset.
Switch
Note: The switch is recessed and must be pushed with a thin
object - such as the end of a paper clip, or a ballpoint pen.
4
Firmware
During normal operation and while performing a firmware
Upgrade
upgrade, this switch should be in the NORMAL position. If a
Recovery
firmware upgrade operation does not complete successfully, this
Switch
switch is used to perform a firmware upgrade recovery.
Note: This is only for performing a local firmware upgrade
(see Firmware Upgrade Recovery, page 45) for details.
5
Firmware
The Firmware Upgrade Cable that transfers the firmware upgrade
Upgrade
data from the administrator's computer to the KH1508i / KH1516i
Port
(see page 40), plugs into this RJ-11 connector.
Note: This is only for performing a local firmware upgrade
(see Firmware Upgrade Recovery, page 45) for details.
6
Power LED Lights to indicate that the KH1508i / KH1516i is powered up and
ready to operate.
7
Station ID
The KH1508i / KH1516i's Station ID is displayed here. If this is a
LED
Single Station installation (see page 12), or the First Station on a
Daisy Chained installation (see page 15), the KH1508i / KH1516i
has a Station ID of 01.
On a Daisy Chained installation, the KH1508i / KH1516i auto-senses
its position and displays the Station ID that corresponds to its place in
the chain. (see Port ID Numbering, page 19, for details).
Press a switch to give the KVM focus to the computer attached
to its corresponding port.
Simultaneously pressing Buttons 1 and 2 for 3 seconds
performs a Keyboard and Mouse Reset.
Simultaneously pressing Buttons 7 and 8 starts Auto Scan
Mode.
An ONLINE LED lights GREEN to indicate that the computer
attached to its corresponding port is up and running. A flashing
LED indicates that the Port is being used for cascading to
another switch.
A SELECTED LED lights ORANGE to indicate that the
computer attached to its corresponding port is the one that has
the KVM focus. The LED is steady under normal conditions, but
flashes when its port is accessed under Auto Scan Mode.
Chapter 1. Introduction
Description
7
Advertisement
Table of Contents
