WL-566gM Wireless Router User Manual
If you are using PPTP services, select
A D S L c o n n e c t i o n t h a t r e q u i r e s
username, password and IP address.
It is know as PPTP. Fill in the username,
password and IP address provided by your
ISP into the ﬁelds. Click Next to continue.
Static IP user
If you are using ADSL or other connection
type that uses static IP addresses,
select ADSL or other connection type
that uses static IP address. Input the
IP address, subnet mask, and default
gateway provided by your ISP. You can
choose to specify DNS servers, or select
to get DNS information automatically.
After the connection type setting is
complete, you are to set up your wireless
interface. Specify to your wireless router
an SSID (Service Set Identifier), which
is a unique identiﬁer attached to packets
sent over WLAN. This identiﬁer emulates
a password when a device attempts to
communicate with your wireless router via
WLAN. To connect to a wireless router,
your wireless card must use the same
If you want to protect transmitted data, select a middle or high Security Level to enable
Medium: Only users with the same WEP key settings can connect to your wireless router and
transmit data using 64bits or 128bits WEP key encryption.
High: Only users with the same WPA pre-shared key settings can connect to your wireless
router and transmit data using TKIP encryption.