Chapter 8
Configuring SDM Templates
This is an example of an output display when you have changed the template and have not reloaded the
switch:
Switch# show sdm prefer
The current template is "desktop routing" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses:
number of igmp groups + multicast routes:
number of unicast routes:
number of qos aces:
number of security aces:
On next reload, template will be "aggregate routing" template.
To return to the default template, use the no sdm prefer global configuration command.
This example shows how to configure a switch with the routing template (the desktop routing template
for a desktop switch or the aggregator routing template for a Catalyst 3750-12S).
Switch(config)# sdm prefer routing
Switch(config)# end
Switch# reload
Proceed with reload? [confirm]
This example shows how to configure the desktop routing template on a Catalyst 3750-12S switch:
Switch(config)# sdm prefer routing desktop
Switch(config)# end
Switch# reload
Proceed with reload? [confirm]
This example shows how to configure the IPv4-and-IPv6 default template on a desktop switch:
Switch(config)# sdm prefer dual-ipv4-and-ipv6 default
Switch(config)# exit
Switch# reload
Proceed with reload? [confirm]
Displaying the SDM Templates
Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
Use the show sdm prefer [access | default | dual-ipv4-and-ipv6 {default | vlan} |routing | vlan
[desktop]] privileged EXEC command to display the resource numbers supported by the specified
template.
Note
The desktop keyword is available only on Catalyst 3750-12S aggregator switches.
OL-8550-02
number of directly connected hosts:
number of indirect routes:
Displaying the SDM Templates
3K
1K
11K
3K
8K
512
1K
Catalyst 3750 Switch Software Configuration Guide
8-7
Need help?
Do you have a question about the 3750G - Catalyst Integrated Wireless LAN Controller and is the answer not in the manual?