Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual page 91

Chapter 2 Using the Command-Line Interface
If your switch is already configured, you can access the CLI through a local console connection or
through a remote Telnet session, but your switch must first be configured for this type of access. For
more information, see the
You can use one of these methods to establish a connection with the switch:
Connect the switch console port to a management station or dial-up modem. For information about
•
connecting to the console port, see the switch getting started guide or hardware installation guide.
Use any Telnet TCP/IP or encrypted Secure Shell (SSH) package from a remote management
•
station. The switch must have network connectivity with the Telnet or SSH client, and the switch
must have an enable secret password configured.
For information about configuring the switch for Telnet access, see the
for a Terminal Line" section on page
Changes made by one Telnet user are reflected in all other Telnet sessions.
For information about configuring the switch for SSH, see the
Shell" section on page
After you connect through the console port, through a Telnet session or through an SSH session, the
user EXEC prompt appears on the management station.
OL-8550-02
"Setting a Telnet Password for a Terminal Line" section on page
9-6. The switch supports up to 16 simultaneous Telnet sessions.
9-37. The switch supports up to five simultaneous secure SSH sessions.
Catalyst 3750 Switch Software Configuration Guide
Accessing the CLI
9-6.
"Setting a Telnet Password
"Configuring the Switch for Secure
2-11