Spanning Tree And Redundant Connectivity; Spanning-Tree Address Management; Accelerated Aging To Retain Connectivity - Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual

Chapter 18 Configuring STP

Spanning Tree and Redundant Connectivity

You can create a redundant backbone with spanning tree by connecting two switch interfaces to another
device or to two different devices, as shown in
interface but enables it if the other one fails. If one link is high-speed and the other is low-speed, the
low-speed link is always disabled. If the speeds are the same, the port priority and port ID are added
together, and spanning tree disables the link with the lowest value.
Figure 18-4
You can also create redundant links between switches by using EtherChannel groups. For more
information, see

Spanning-Tree Address Management

IEEE 802.1D specifies 17 multicast addresses, ranging from 0x00180C2000000 to 0x0180C2000010, to
be used by different bridge protocols. These addresses are static addresses that cannot be removed.
Regardless of the spanning-tree state, each switch in the stack receives but does not forward packets
destined for addresses between 0x0180C2000000 and 0x0180C200000F.
If spanning tree is enabled, the CPU on each switch in the stack receives packets destined for
0x0180C2000000 and 0x0180C2000010. If spanning tree is disabled, each switch in the stack forwards
those packets as unknown multicast addresses.

Accelerated Aging to Retain Connectivity

The default for aging dynamic addresses is 5 minutes, the default setting of the mac address-table
aging-time global configuration command. However, a spanning-tree reconfiguration can cause many
station locations to change. Because these stations could be unreachable for 5 minutes or more during a
reconfiguration, the address-aging time is accelerated so that station addresses can be dropped from the
address table and then relearned. The accelerated aging is the same as the forward-delay parameter value
(spanning-tree vlan vlan-id forward-time seconds global configuration command) when the spanning
tree reconfigures.
OL-8550-02
Spanning Tree and Redundant Connectivity
Active link
Blocked link
Chapter 34, "Configuring EtherChannels and Link-State Tracking."
Understanding Spanning-Tree Features
Figure 18-4]. Spanning tree automatically disables one
Workstations
Catalyst 3750 Switch Software Configuration Guide
18-9