Configuring Voice Vlan; Default Voice Vlan Configuration; Voice Vlan Configuration Guidelines - Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual

Chapter 15

Configuring Voice VLAN

Untagged traffic from the device attached to the Cisco IP Phone passes through the phone unchanged,
Note
regardless of the trust state of the access port on the phone.
Configuring Voice VLAN
These sections contain this configuration information:
•
•
•

Default Voice VLAN Configuration

The voice VLAN feature is disabled by default.
When the voice VLAN feature is enabled, all untagged traffic is sent according to the default CoS
priority of the port.
The CoS value is not trusted for IEEE 802.1p or IEEE 802.1Q tagged traffic.

Voice VLAN Configuration Guidelines

These are the voice VLAN configuration guidelines:
•
•
•
•
•
•
OL-8550-02
Default Voice VLAN Configuration, page 15-3
Voice VLAN Configuration Guidelines, page 15-3
Configuring a Port Connected to a Cisco 7960 IP Phone, page 15-4
You should configure voice VLAN on switch access ports; voice VLAN is not supported on
trunk ports. You can configure a voice VLAN only on Layer 2 ports.
Voice VLAN is only supported on access ports and not on trunk ports, even though the
Note
configuration is allowed.
The voice VLAN should be present and active on the switch for the IP phone to correctly
communicate on the voice VLAN. Use the show vlan privileged EXEC command to see if the
VLAN is present (listed in the display). If the VLAN is not listed, see
VLANs," for information on how to create the voice VLAN.
Do not configure voice VLAN on private VLAN ports.
The Power over Ethernet (PoE) switches are capable of automatically providing power to Cisco
pre-standard and IEEE 802.3af-compliant powered devices if they are not being powered by an AC
power source. For information about PoE interfaces, see the
Mode on a PoE Port" section on page
Before you enable voice VLAN, we recommend that you enable QoS on the switch by entering the
mls qos global configuration command and configure the port trust state to trust by entering the mls
qos trust cos interface configuration command. If you use the auto-QoS feature, these settings are
automatically configured. For more information, see
You must enable CDP on the switch port connected to the Cisco IP Phone to send the configuration
to the phone. (CDP is globally enabled by default on all switch interfaces.)
"Configuring a Power Management
11-21.
Chapter 33, "Configuring QoS."
Catalyst 3750 Switch Software Configuration Guide
Configuring Voice VLAN
Chapter 13, "Configuring
15-3