Understanding Spanning-Tree Features; Spanning-Tree Interface States - Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual

Understanding Spanning-Tree Features

From learning to forwarding or to disabled
•
From forwarding to disabled
•
Figure 18-2
Figure 18-2
Power-on
initialization
Blocking
state
Listening
state
Learning
state
Forwarding
state
When you power up the switch, spanning tree is enabled by default, and every interface in the switch,
VLAN, or network goes through the blocking state and the transitory states of listening and learning.
Spanning tree stabilizes each interface at the forwarding or blocking state.
When the spanning-tree algorithm places a Layer 2 interface in the forwarding state, this process occurs:
The interface is in the listening state while spanning tree waits for protocol information to move the
1.
interface to the blocking state.
While spanning tree waits the forward-delay timer to expire, it moves the interface to the learning
2.
state and resets the forward-delay timer.
In the learning state, the interface continues to block frame forwarding as the switch learns
3.
end-station location information for the forwarding database.
When the forward-delay timer expires, spanning tree moves the interface to the forwarding state,
4.
where both learning and frame forwarding are enabled.
Catalyst 3750 Switch Software Configuration Guide
18-6
illustrates how an interface moves through the states.

Spanning-Tree Interface States

Disabled
state
Chapter 18 Configuring STP
OL-8550-02