Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual page 857

Chapter 35 Configuring IP Unicast Routing
Table 35-7
Feature
Distance
EIGRP log-neighbor changes
IP authentication key-chain
IP authentication mode
IP bandwidth-percent
IP hello interval
IP hold-time
IP split-horizon
IP summary address
Metric weights
Network
1
NSF
NSF capability
Offset-list
Router EIGRP
Set metric
Traffic-share
Variance
1. NSF = Nonstop Forwarding
2. EIGRP NSF awareness is enabled for IPv4 on Catalyst 3550, 3560 and 3750 switches running the IP services image, Cisco
IOS Release 12.2(25)SEC or later.
To create an EIGRP routing process, you must enable EIGRP and associate networks. EIGRP sends
updates to the interfaces in the specified networks. If you do not specify an interface network, it is not
advertised in any EIGRP update.
If you have routers on your network that are configured for IGRP, and you want to change to EIGRP, you
Note
must designate transition routers that have both IGRP and EIGRP configured. In these cases, perform
Steps 1 through 3 in the next section and also see the
You must use the same AS number for routes to be automatically redistributed.
OL-8550-02
Default EIGRP Configuration (continued)
Awareness
Default Setting
Internal distance: 90.
External distance: 170.
Disabled. No adjacency changes logged.
No authentication provided.
No authentication provided.
50 percent.
For low-speed nonbroadcast multiaccess (NBMA) networks:
60 seconds; all other networks: 5 seconds.
For low-speed NBMA networks: 180 seconds; all other networks:
15 seconds.
Enabled.
No summary aggregate addresses are predefined.
tos: 0; k1 and k3: 1; k2, k4, and k5: 0
None specified.
2
Enabled . Allows Layer 3 switches to continue forwarding packets
from a neighboring NSF-capable router during hardware or software
changes.
Disabled.
Beginning with Cisco IOS Release 12.2(35)SE, the
Note
Catalyst 3750 switch supports EIGRP NSF-capable routing
for IPv4.
Disabled.
Disabled.
No metric set in the route map.
Distributed proportionately to the ratios of the metrics.
1 (equal-cost load balancing).
"Configuring Split Horizon" section on page
Catalyst 3750 Switch Software Configuration Guide
Configuring EIGRP
35-24.
35-37