Installing Pcmcia Options - Texas Instruments TravelMate 5000 Series Maintenance Manual

2.3.2
The Notebook has two connector slots for PCMCIA option cards. These two
slots can be used to install one type III or two type I/II credit card size
PCMCIA option cards. Install the PCMCIA options as follows:
1.
2.
3.
Note : After installation or removal of PCMCIA option cards, you must run
the Phoenix PCMCIA PhoenixCARD Manager install software supplied on
hard disk to properly configure the PCMCIA card.
2-6 Installation

Installing PCMCIA Options

Review the installation instructions supplied with the PCMCIA option
card(s).
Hold the card at the end opposite the connector pins with the label side
up. Insert the card into an unused slot on the right side of the
Notebook.
If the option requires external cabling (e.g. Modem option), connect
external cabling at this time.
Telephone Jack Connection
(PCMCIA Modem Option)
Figure 2-4 Installing PCMCIA Options
(XJACK PCMCIA Option Shown)