Installing Pcmcia Options - Texas Instruments Extensa 660 Series Maintenance Manual

7.
Replace the Advanced PCI Access Cover and all components removed in Steps
1 and 2 above. Refer to the User Documentation for the Advanced PCI option
for further instructions.
Bottom of Notebook

2.3.4 Installing PCMCIA Options

The Notebook has two connector slots for PCMCIA option cards. These two slots can be
used to install one Type III or two Type I/II credit card size PCMCIA option cards. You
can install a PCMCIA (PC card) without turning the computer off.
Use the following procedure to install a PCMCIA option:
1. Review the installation instructions supplied with the PCMCIA option card(s).
2. Hold the card at the end opposite the connector pins with the label side up.
Insert the card into an unused slot on the left side of the Notebook.
3. If the option requires external cabling (e.g., modem option), connect external
cabling at this time.
Note: After installation of a PCMCIA option card, Windows 95 displays the New
Hardware Found dialog box to help you configure the new device. To remove a
card, click on the PCMCIA icon; then, press the appropriate PC Card Release
lever (or press both levers for a Type III device) and remove the option.
Advanced PCI Compartment
Figure 2-2 Installing an Advanced PCI Card Option
Advanced PCI Connector
Compartment
with cover removed
Installation 2-5