Removing/Replacing Expansion Ram Boards; Figure; Expansion Ram Board(S), Removal/Replacement - Texas Instruments TravelMate 5000 Series Maintenance Manual

5.5.5 Removing/Replacing Expansion RAM
Boards
To remove and replace the expansion RAM board(s),perform the following
procedure:
1. Power down the notebook, remove the battery packs, and disconnect the
AC Adapter, if installed.
2. Disconnect any peripheral device interface cables from the external
interface connectors and remove any installed PCMCIA options.
3. Turn the notebook upside down on a padded surface.
4. Remove the two holding screws and remove the floppy bezel as shown in

Figure 5-8.

5.
Remove the RAM expansion PWB and Shuttle RAM PWB (if installed).
6. Replacement is essentially the reverse of Steps 1 through 3 above.
Figure 5-8 Expansion RAM Board(s), Removal/Replacement
Field Service 5-13